Description

The 141 Series Rolled Edge Retrofit Joint Covers are manufactured with a rolled edge for extra sturdiness, while holding the same face width as a regular joint cover. Retrofit Joint Covers are manufactured for application after siding installation has been completed and the seams open up, or the siding was installed with too large of a gap at the seam to be covered by the regular joint covers. Retrofit joint covers do not have the rib on the back, so they are more flexible and will need fastening to keep the part in place. These joint covers are wider than the regular parts. Retrofit joint covers are stocked in a limited range of sizes and styles (see chart below), but can be produced in a wide variety of styles, widths, finishes, and lengths.

• Can be used over previously caulked butt joints
• Flat Back for easy installation on preinstalled siding
• For 3/8 x 8 or 1/2 x 8 Self-Aligning siding
• Rolled Edge for increased stiffness